[. . . ] If a prompt appears asking you to set the language and country/region, use the arrows to select your language from the list of languages, and press OK to confirm. â· If a prompt appears asking you to install print cartridges, go to the next step in this guide. [. . . ] Follow the software onscreen instructions, and continue to the next step. On the Connection Type screen, make sure to select through the network. IMPORTANT: For the first time install only, no printers will be found during the network search. When asked, connect your HP All-in-One to your computer using the supplied USB cable. This connection is temporary while wireless network settings are sent to your printer. If your network uses security, a prompt appears for the WEP key or WPA passphrase. You will see a dialog box that confirms that the wireless connection has been established. If you have additional computers on your network, refer to the Basics Guide for instructions. Connect the USB cable to the port on the back of the HP All-in-One, and then to any USB port on the computer. When the Select Device screen appears, select your device and then click Continue. When the Network Setup screen appears, select your wireless network name (SSID) and click Continue. If you have additional computers on your network, refer to the Basics Guide for instructions. [. . . ] To change from USB to Wireless, start the Setup Assistant, select your device and click Continue. Select Configure your device for a wireless network, click Continue, and follow the instructions. [. . . ]